Korg RK-100S 2 User Manual

RK-100S 2 Owner's Manual
14
Controlling the lter with your left hand free
1. While no sound is being produced, hold down the
SHIFT button and pressthe LONG RIBBON FILTER/
HOLD button.
The FILTER/HOLDbuonislitup.
2. Play the keyboard.
Sound continues to be produced.
3. Use the ribbon.
Seepage13“Controllingthelterofthe
continuant”
Tip: Thedirectionwheretheeectisappliedwhentherib-
bon is used can be changed with the sound editor software
(when the RK-100S 2 is connected to a computer via USB).
4. Press the FILTER/HOLD button again to turn o the
button and stop the continuant.
Playing arpeggios
The arpeggiator is a function that automatically plays a
broken chord (arpeggio) when you hold down a chord
on the keyboard.
1. Select a synthesizer program.
The arpeggiator can also be used with the vocoder
program;however,abeereectcanbeachieved
with a synthesizer program. In addition, we
recommend a sound with a short sustain.
2. Press the ARP button so that the LED is lit up.
The arpeggiator is turned on.
TheARPbuonislitup,andthefavoritesbuonsA
–Haresequentiallylitup.
3. Hold down a chord in the keyboard.
An arpeggio will start playing.
Thearpeggiopaernthatisplayedcanbechanged
(see14page“Arpeggiopaernseings”).
4. Press the TAP button to adjust the tempo.
TheTAPbuonislitingreen,andthetempo
appears in the display.
5. Press the ARP button so that the LED is turned o.
The arpeggio stops playing.
3
2
1
1
1
3
4
2,5
Continuing playing with your hand o
the keyboard (latch)
The operation of the arpeggiator when you take your
handothekeyboardcanbespecied.
1. Hold down the ARP button until it is lit up in green.
WhentheARPbuonislitupingreen,thelatchis
turned on, and the arpeggiator will continue to play
evenafteryoutakeyourhandothekeyboard.
Note: Regardless of whether the arpeggiator is turned
onoro,holdingdowntheARPbuonwillturnonthe
arpeggiator as well as the latch.
2. Press the ARP button to turn o the arpeggiator.
Thelatchisturnedoatthesametimethatthe
arpeggiatoristurnedo.
Arpeggio pattern settings
This allows you to select the type of arpeggio produced
when the arpeggiator is on and a keyboard key is pressed.
Inaddition,noteswithintheselectedarpeggiopaern
canbeturnedon/o.
1. Hold down the SHIFT button and press the ARP
button.
Thearpeggiopaernseing
appears in the display.
Withthefavoritesbuons
A–Husedasthearpeggiator
stepkeys,onlythebuons
corresponding to the enabled
steps are lit up (note one).
2. Use the OCTAVE +/- buttons or the SOUND/
FAVORITE BANK lever to specify the arpeggio
pattern.
UP: Notes will be played consecutively from low
pitches to high.
dn (Down): Notes will be played consecutively from
high pitches to low.
AL.1: Up and Down will be alternated. (The highest
and lowest notes will be played once.)
AL.2: Up and Down will be alternated. (The highest
and lowest notes will be played twice, once on the
way up, and once on the way down.)

Korg RK-100S 2 Specifications

General

Brand	Korg
Model	RK-100S 2
Category	Musical Instrument
Language	English