Trouble shooting
19
Trouble shooting
If you suspect a malfunction, please check the following
points. If this does not resolve the problem, please
contact a nearby dealer.
Power does not turn on
•Is the AC adapter connected to an AC outlet? (
See page
8 "Connections"
)
•
Arethebaeriesdepleted?
HolddowntheSHIFTbuonandpresstheGbuon
tochecktheremainingbaerypowerlevel(See page
17“Baerytypeandremainingpower”).
•
Havethebaeriesbeeninsertedwiththecorrect
orientation? (Seepage9“Usingbaeries”)
Automatically turns o
•Hastheautopowerofunctionbeenenabled?(See
page17“Autopowerofunction”)
No sound
• Are your powered monitors or headphones connected to
the jack correctly ? (See page 8 “Connections”)
•Is the connected monitor system powered-on, and is
the volume raised?
•Is the VOLUME knob set to a position where sound
will be output?
Nothing happens when the OCTAVE UP or DOWN
button is pressed.
•Is a shift function being set?
PresstheSHIFTbuontoexittheshiftfunction.
Cannot input sound
•Has the mic that will be used as the modulator with
the vocoder program been correctly connected to the
INPUT jack?
•Has the Input select switch been set appropriately?
Arpeggiator will not start
•Isthearpeggiatoron(ARPbuonlitup)?
No sound is produced when the RK-100S 2 is
controlled with the long ribbon controller
•Have the shift functions been used to change the long
ribbon velocity to oFF?
SelectanyseingotherthanoFF.(See page 16 “Long
ribbon velocity”)
•Have the shift functions been used to change the long
ribbon MIDI channel?
Specify the same MIDI channel for producing sound.
(See page 16 “Long ribbon MIDI channel”)
No sound produced from an external MIDI sound
generator that’s connected with a MIDI cable
•Is the MIDI cable connected correctly? (See page 8
“Connections”)
•Does the MIDI channel of the external MIDI device
match the MIDI channel of the RK-100S 2? (See page
16 “Global MIDI channel”)