6
[3] EG-INTENSITY:
Controls the filter EG intensity.
[4] EG-RELEASE:
Controls the filter/amp release time.
B-mode
[1] ASSIGNABLE 1:
[2] ASSIGNABLE 2:
[3] ASSIGNABLE 3:
[4] ASSIGNABLE 4:
Controls the functions that are assigned in each mode
(Program, Combination, Sequencer, or Sampling (if the
EXB-SMPL option is installed)).
C-mode
[1] ———: not used
[2] ARP-GATE:
Controls the gate time (note duration) of the arpeggi-
ated notes. At the center position (12 o’clock), the set-
ting of the arpeggiator “Gate” parameter will be used.
Rotating the knob toward the left will shorten the time,
and rotating it toward the right will lengthen the time.
[3] ARP-VELOCITY:
Controls the velocity (playing strength) of the arpeggi-
ated notes. At the center position (12 o’clock), the set-
ting of the arpeggiator “Velocity” parameter will be
used. Rotating the knob toward the left will weaken
the velocity, and rotating it toward the right will
strengthen the velocity.
[4] TEMPO:
Controls the tempo of the arpeggiator or of the
Sequencer mode .
The LED beside “TEMPO” will blink at quarter note
intervals of the specified tempo.
7. Mode keys, [COMPARE] key
These keys are used to enter each mode.
Pressing a key will enter the corresponding mode (the
key will light). (
☞p.14)
[COMBI] key
Combination mode will be selected.
[PROG] key
Program mode will be selected.
[SEQ] key
Sequencer mode will be selected.
[GLOBAL] key
Global mode will be selected
[MEDIA] key
Media mode will be selected.
[COMPARE] key
Use this key when you wish to compare the sound of
the program or combination that you are currently
editing with the un-edited sound that was written into
memory. You can also use this key to make “before and
after” comparisons when recording or editing in
Sequencer mode (
☞p.15).
[SAMPLING] (EXB-SMPL) key
This key selects the Sampling mode.
This is valid only if the separately sold EXB-SMPL
option is installed.
If the separately sold EXB-SMPL option is not
installed, pressing the [SAMPLING] key will cause
a message of “No Sampling Upgrade Installed” to
be displayed.
8. [TIMBRE/TRACK] key,
[F1 T1/T9] … [F8 T8/T16] keys
Function [F1]–[F8] keys
These keys select the tabs that are displayed in each
page. They are also used to execute utilities and other
functions.
Timbre/track select [T1/T9]–[T8/T16] keys
By holding down the [TIMBRE/TRACK] key and
pressing a [T1/T9]–[T8/T16] key, you can select the
timbre/track parameters corresponding to the key
number.
When a single page displays the parameters for tim-
bres 1–8 of a Combination or for tracks 1–8/9–16 of
Sequencer mode, these keys select one of these tim-
bres/tracks.
9. LCD screen
Here you can select pages, and parameters, and set val-
ues. (
☞p.10)
10.VALUE controllers
The following VALUE controllers are used to set the
value of the selected parameter (
☞p.15).
To Next Page
Loading...
