19
Quick Start
Listening to a demo song
Playing a cue list
Here’s how to playback the demonstration cue list. By
using a cue list, you can repeatedly play multiple
songs that you specify in the cue list, or play songs
consecutively. (
☞p.71)
1 Press the [MENU] key.
2 Press the [F2] key to select “Cue,” and then press
the [F8] (“OPEN”) key.
The SEQ 2.1: Cue List, Setup&Play page will appear.
3 Press the [START/STOP] key.
4 To stop playback, press the [START/STOP] key
once again.
If the last step is End, playback will stop automati-
cally when it reaches that point. If the last step is
Continue to Step01, playback will return to the first
step and continue.
To select a cue list, choose “Cue List Select,” and
use the same procedure as when selecting a song.
Refer to step 4 above.
Contents of the preloaded data and demo songs
Preload PCG
• Preloaded data (programs, combinations, drum
kits, arpeggio patterns, global settings)
When you load the preloaded data, it will be writ-
ten into internal memory. This data is preserved
even when the power is turned off.
When this data is loaded, the PCG data that had
been previously written will be replaced. If you do
not want to lose this data, save it on SmartMedia
beforehand. (
☞p.45)
Demo Songs
• Demonstration song and demonstration cue list
data
This data is loaded into the internal sequencer
memory. The data will be lost when the power is
turned off.
When you load All Demo Songs, the data that had
been written before loading this data will be
rewritten. If you wish to keep this data, you must
first save it on a SmartMedia before loading All
Demo Songs. (
☞p.45)
To Next Page
Loading...
Need help?
General
