116
Adjusting the contrast (brightness)
of the LCD screen
Use the GLOBAL 1.1: System, Preference page “LCD
Contrast” to make adjustments. (
☞p.117, PG p.125)
Using this instrument as a data
filer
MIDI exclusive data transmitted from an external
device can be received by this instrument and saved on
a SmartMedia (the Data Filer function). This is done
using the Media mode Save page “Save Exclusive”
(
☞PG p.150).
Shortcuts
[MENU] key + numeric keys [0]–[9] x2
• Access the various pages within each mode. Hold
down the [MENU] key, and use numeric keys [0]–
[9] to input a two-digit page number.
[MENU] key + [ ], [ ] keys
• Access the various pages within each mode. Hold
down the [MENU] key, and use the [ ], [ ] keys
to move.
[TIMBRE/TRACK] key + function keys [F1]–[F8]
• Access the parameters within each page. In pages
of Combination Sequencer mode that show timbres
1–8/tracks 1–8 or 9–16 (such as COMBI 1.1: Play,
Prog), hold down the [TIMBRE/TRACK] key and
press the [F1 T1/T9]–[F8 T8/T16] keys to move the
cursor.
[ENTER] key + numeric keys [0]–[9]
• Access the Utility menu commands of each page
(up to ten items). Hold down the [ENTER] key and
press a numeric key [0]–[9] to select from up to ten
of the Utility menu items.
[ENTER] key + keyboard
By holding down the [ENTER] key and pressing a note
on the keyboard of the TRITON Le, you can perform
the following input operations.
• Input note number values or velocity values
• Select “KEY” in GLOBAL 5.1: DKit, SEQ 5.1: RPPR,
RPPR Setup page
[ENTER] key + [LOCATE] key
• In Sequencer mode, set the current location as the
“Location” (equivalent to the Utility menu
command “Set Location”)
To Next Page
Loading...
Need help?
General
