9
Introduction
Front and rear panel
you to use the pedal to control the volume, etc.
(
☞p.113)
ASSIGNABLE SWITCH jack
A separately sold on/off foot switch such as the Korg
PS-1 foot switch can be connected here (
☞p.13).
Its function can be assigned in Global mode, allowing
you to use the foot switch as a modulation controller,
to select programs or combinations, or to start/stop the
sequencer (
☞p.113).
DAMPER jack
A separately sold switch-type pedal such as the Korg
DS-1H damper pedal can be connected here.
If a DS-1H is connected, it will function as a half-
damper pedal. In order to ensure that the half-damper
pedal functions correctly, please adjust the polarity and
the sensitivity (
☞PG p.124, 126).
If any other switch-type pedal is connected, it will
function as a damper switch.
Set the polarity according to the pedal that you con-
nected. (
☞PG p.126)
6. MIDI
MIDI IN connector
Musical data and sound settings etc. are received at
this connector.
Use this to play TRITON Le from another connected
MIDI device (
☞PG p.229).
MIDI OUT connector
Musical data and sound settings etc. are transmitted
from this connector.
Use this to control another connected MIDI device
from TRITON Le (
☞PG p.229).
MIDI THRU connector
Musical data and sound settings etc. that are received
at the MIDI IN connector are re-transmitted without
change from the MIDI THRU connector.
You can use this to connect multiple MIDI devices via
MIDI cables (
☞PG p.229).
7. EXB-SMPL
(If the separately sold EXB-SMPL option is
installed)
These connectors are used to sample mono or stereo
audio from a mic or audio device (
☞p.34, 38), or to use
the internal effect processor to apply effects. (
☞p.111)
The MIC/LINE level select switch ([MIC/LINE]
switch) and the level adjustment knob ([LEVEL] knob)
allow a wide range of audio sources to be input, from
mic level to line level.
SCSI connector
Use a SCSI cable to connect this to a SCSI-compatible
device (hard disk drive, CD-ROM drive, etc.). (
☞ EXB-
SMPL owner’s manual)
AUDIO INPUT 1, 2 jacks
These are unbalanced phone audio input jacks. (
☞p.13)
Connect them to the OUTPUT jack(s) of your external
audio device or mic.
[LEVEL] knob
This knob adjusts the input level of the AUDIO INPUT
1, 2 jacks. (
☞p.34)
[MIC/LINE] switch
This switch selects the input level of the AUDIO
INPUT 1, 2 jacks. (
☞p.34)
To Next Page
Loading...
