Kramer Electronics Ltd.
VIA Connect² – For Web Administrator: Gateway Dashboard
Wi-Fi Settings
VIA Connect² can be setup to use Wi-Fi in two modes: AP or Client.
AP (access point) mode – Use this option if your device is connected to a LAN.
Your VIA Connect² can setup its own Wi-Fi network which can be used by guests to
connect to meetings without giving access to the wider network or requiring them to
have a network login.
Client mode – Use this option to connect your device to a local network without
using a LAN connection.
These settings can also be controlled from the Gateway Dashboard Page.
Figure 100: Wi-Fi Settings on Gateway Dashboard
To connect to Wi-fi:
1. See Settings – Logging into the Settings tab on page 83.
2. Click Wi-Fi; The Wi-Fi tab appears.
3. Switch the Wi-Fi on. The switch turns green. The Wi-fi Settings appear.
To Next Page
Loading...
