Kramer VP-773A - Page 117

VP-773A - The VP-773A RS-232 Communication Protocol
111
111
Network settings commands
Network settings commands require admin authorization
Command
Syntax
Response
Address
NTMC?
Set subnet
mask
NET-MASK SUBNET_MASK
NTMSK
NET-MASK SUBNET_MASK
RESULT
Read subnet
mask
NET-MASK?
NTMSK?
NET-MASK SUBNET_MASK
Set gateway
address
NET-GATE GATEWAY_ADDRESS
NTGT
NET-GATE
GATEWAY_ADDRESS RESULT
Read subnet
mask
NET-GATE?
NTGT?
NET-GATE
GATEWAY_ADDRESS
Set DHCP
mode
NET-DHCP DHCP_MODE
NTDH
NET-DHCP DHCP_MODE
RESULT
Read subnet
mask
NET-DHCP?
NTDH?
NET-DHCP DHCP_MODE
DHCP_MODE =
0 (factory default) – Don't use DHCP (Use IP set by factory or IP set command).
1 – Try to use DHCP, if unavailable use IP as above.
2– Try to use DHCP, if unavailable use AUTO-IP as described here:
http://support.microsoft.com/kb/q307287/ .
After setting DHCP_MODE to 1 or 2 you need to reset the device
Change
protocol
Ethernet port
ETH-PORT PROTOCOL , PORT
ETH-PORT PROTOCOL ,PORT
RESULT
Read protocol
Ethernet port
ETH-PORT? PROTOCOL
ETH-PORT PROTOCOL , PORT
PROTOCOL = TCP / UDP (transport layer protocol)
PORT =
Ethernet port to enter protocol 3000 commands.
1-65535 = User defined port
0 - reset port to factory default (50000 for UDP, 5000 for TCP)
Load new
peripheral
firmware P
Step 1: LDFW SIZE
Response 1: READY or LDFW SIZE ERR###
Step 2: If ready was received, send FIRMWARE_DATA
P
Response 2: LDFW SIZE RESULT
Load new video
core firmware
Step 1: LDFWS SIZE
Response 1: READY or LDFWS SIZE ERR###
Step 2: If ready was received, send FIRMWARE_DATA
P
Response 2: LDFWS SIZE RESULT
Load new
audio/graphic
memory file
Step 1: LDMFS SIZE
Response 1: READY or LDMFS SIZE ERR###
Step 2: If ready was received, send FIRMWARE_DATA
P
Response 2: LDMFS SIZE RESULT