Safety
13
Pos: 14.7.15 /BA/Si cherheit/Wartung/ Wartung Swadro TC 880 X-tr @ 242\m od_1395323043085_7 8.docx @ 1899505 @ @ 1
4.8 Maintenance
1 Always make certain that the drive and the engine are switched off before doing any
repairs, maintenance or cleaning! - Remove the ignition key!
2 Regularly check that nuts and bolts are properly seated and tighten if necessary!
3 When performing maintenance work with the machine raised, always secure it with suitable
supporting elements!
4 Oils, greases and filters must be disposed of correctly!
5 Always disconnect the power supply before working on the electrical system!
6 If protective devices and guards are subject to wear, check them regularly and replace them
in good time!
7 When performing electrical welding work on the vehicle and mounted devices, turn power
supply off at main battery switch or disconnect generator cable and battery!
8 Replacement parts must at least comply with the technical requirements set by the
manufacturer of the implements! This is guaranteed by original KRONE spare parts!
9 Only use nitrogen for filling pneumatic accumulators - risk of explosion!
Pos: 14.7.16 /Layout Module ---------------Seitenumbruch------- --------- @ 0\mod_1196175311 226_0.docx @ 4165 @ 22 @ 1
To Next Page
Loading...
