Krone Swadro TC 880 - For Design with Electrical Single-Rotor Lifting Mechanism

Driving and Transport
55
Pos: 27.29 /Übersc hriften/Überschri ften 3/A-E/Bei Ausführ ung mit elektrischer E inkreiselaushebung @ 77\mod_1310050553942 _78.docx @ 667522 @ @ 1
10.3.3 For design with electrical single-rotor lifting mechanism
Pos: 27.30 /BA/Bedienun g /Schwader/Krei selarme senken/heben/ Kreiselarme heben_I _elektrische Einkr eiselaushebung SW 900# Bi ld @ 162\mod_136568784741 3_78.docx @ 1418842 @ 2 @ 1
SW9000033
3
1
2
4
Fig. 32
Pos: 27.31 /BA/Bedienun g /Schwader/Krei selarme senken/heben/ Kreiselarme heben_I _elektrische Einkr eiselaushebung Swadr o TC 880 @ 266\mod_1400665906 686_78.docx @ 2020077 @ 2 @ 1
• Prerequisite:
The rotors are in working position.
– The tractor is switched on.
The control unit is switched on via switch (1) (0 > 1).
The switch (3) is in position II.
• Raise the rotors to headland position by using the single-action control unit.
• Retract the rotor arms by using the double-action control unit until the indicator arrow (4) is
in the centre between 7.8.
• Move switch (2) upward into position V, keep it pressed and raise rotors simultaneously into
transport position by using the single-action control unit.
The piston rod facing the machine side must be completely retracted.
Pos: 27.32 /Layout Module /----------------Leerzeile-------------------- @ 240\mod_1395147357027_0.doc x @ 1890988 @ @ 1
Pos: 27.33 /BA/Bedienun g /Schwader/Krei selarme senken/heben/ Kreiselarme heben_I I_SW 900# Bild @ 162\mod_1365 761985219_78.doc x @ 1420163 @ @ 1
SW9000035
4
Fig. 33
Pos: 27.34 /BA/Bedienun g /Schwader/Schal ter (2) loslassen @ 267\mod_1 400741480346_78.d ocx @ 2022051 @ @ 1
• Release switch (2); it moves automatically to position IV.
Pos: 27.35 /BA/Bedienun g /Schwader/Krei selarme senken/heben/ Kreiselarme heben_I I_SW TC 880 Text @ 267\mod_1400740 360243_78.doc x @ 2021964 @ @ 1
• To ensure a transport height of less than 4 m, retract the working width with the double-
action control unit as far as it will go (the indicator arrow (4) is just ahead of the second
screw).
• Move all hydraulic control units to neutral position.
Pos: 27.36 /BA/Bedienun g /Schwader/Bedien box ausschalten @ 267\mod_1 400741418608_78.d ocx @ 2022023 @ @ 1
• Switch off operation panel.
Pos: 27.37 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ 11 @ 1