Operation
57
Pos: 29.1 /Überschri ften/Überschri ften 1/A-E/Bedienung @ 0\mo d_1199789505403_78.doc x @ 34825 @ 2222322223 @ 1
11 Operation
Pos: 29.2 /Überschri ften/Überschri ften 2/U-Z/Vorbereitu ng zum Schwaden @ 134\mod_13 50559748774_78.doc x @ 1188971 @ @ 1
11.1 Preparation for Swathing
Pos: 29.3 /BA/Bedienung / Schwader/Maschi ne ist für Vorwärtsfahr t konzipiert. @ 66\mod_1302 175087311_78.doc x @ 615098 @ 2 @ 1
WARNING! – Do not drive in reverse when using the machine for work.
Effect: Damage to the machine.
The machine is designed to travel forwards. Never reverse while the machine is in operation
and in working position. Lift the rotor first.
Pos: 29.4 /BA/Bedienung / Schwader/Schwaden/ Folgende Arbeitssc hritte werden ... (Schwaden) SW 900# @ 161\mod_1365 668671022_78.docx @ 1416249 @ 22 @ 1
The following work steps are described in this chapter:
– Removing the tine guards from the tine tips
– Lowering the rotor arms to working position
– Releasing rotor locking device
– Swivelling the hoop guards to transport position
– Setting the working width
– Setting the working depth
– Selecting rotor operation
– Travelling on an incline
– Travelling speed und drive speed
– Swathing
– Overload protection
– Parking
Pos: 29.5 /Überschri ften/Überschri ften 2/U-Z/Zinkenschut ze entfernen @ 36\mod_1 262940295076_78.doc x @ 338395 @ @ 1
11.2 Removing the tine protections from the tine tips
Pos: 29.6 /BA/Bedienung / Schwader/Zinken / Zin kenarme/Zinkensc hutze entfernen SW 900# @ 161\ mod_1365599231235_78. docx @ 1415191 @ @ 1
1
3
SW9000013
2
Fig. 35
• Turn off the tractor and secure it against the possibility of rolling back.
• Remove the tine guards (1) from the machine.
• Insert the tine guards into the support (2) and secure them with linch pins (3).
• Repeat this process for the other machine side.
Pos: 29.7 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ 22 @ 1
To Next Page
Loading...
