Krone Swadro TC 880 - 7 Control and Display Elements

Control and Display Elements
25
Pos: 21.1 /Überschri ften/Überschri ften 1/A-E/Bedien- und Anzei geelemente @ 107\mod_1 334231983896_78.d ocx @ 965285 @ 3311 @ 1
7 Control and Display Elements
Pos: 21.2 /BA/Maschi nenbeschreibung/Sc hwader/Funktionsüb ersicht Standard @ 250\ mod_1396939092825_78. docx @ 1936072 @ 333 @ 1
The following table shows the functions on the machine (depending on machine design)
Function Description
Crank on left rotor • Increase or reduce the rotor height of the left rotor.
Crank on right rotor • Increase or reduce the rotor height of the right rotor.
Single-action control unit
(red 1+)
From transport position to working position:
• Pull the operating cable and keep it under tension.
• Float position (red 1+): Lowers the machine from
transport position to working position.
Headland position:
• Pressure (red 1+): Raises the machine from working
position to headland position.
• Float position (red 1+): Lowers the machine from
headland position to working position.
From working position to transport position:
• Switch off PTO drive.
• Pull the operating cable and keep it under tension.
• Pressure (red 1+): Raises the machine from working
position to transport position.
Double-action control unit
(blue 2+/ blue 2-)
Increasing the working width
• Pressure (blue 2+): Increase the working width
Reducing the working width
• Pressure (blue 2+): Reduce the working width
Pos: 21.3 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1