Maintenance
77
Pos: 36.17 /Übersc hriften/Überschri ften 2/A-E/Abweichen des Drehmoment @ 155\mod_1363 620849669_78.doc x @ 1373212 @ @ 1
13.6 Deviating Torque
Pos: 36.18 /BA/W artung/Schwader/Zinken / Zinkenarme/Prüfen der Schrauben an den Zinken nach W artungstabelle_SW TC 880_TS 800 @ 228\mod_1392820024 661_78.docx @ 1833280 @ 1 @ 1
13.6.1 Testing the Screws on the Tines
1
Fig. 50
Testing the Screws on the Tines: According to the Maintenance Table
Pos: 36.19 /BA/W artung/Schwader/Zinken / Zinkenarme/Prüfen der Schrauben an den Zinken_Vor gehen bei abweichendem An zugsdrehmoment @ 240\ mod_1395147752001_78. docx @ 1891022 @ 11222221 @ 1
When having released the screws,
• remove the nut.
• apply adhesive (high-strength) on the threading overhang of the screw.
• lift the tines on the tine end and tighten the nut to the torque specified below.
Pos: 36.20 /BA/W artung/Reifen/Schwader /Anziehdrehmoment der Räder am Fahrwerk SW TC 880 @ 228\mod_1 392819507015_78.d ocx @ 1833119 @ 11 @ 1
13.6.2 Torque of Wheels on the Running Gear
SW9000022_1
Fig. 51
Check locknut: According to the maintenance table
Pos: 36.21 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ 33332 @ 1
To Next Page
Loading...
