Driving and Transport
53
Pos: 27.17 /Übersc hriften/Überschri ften 3/A-E/Bei Ausführ ung ohne Einkreiselaush ebung @ 77\mod_1310110349 917_78.docx @ 667808 @ @ 1
10.3.1 For design without single-rotor lifting mechanism
Pos: 27.18 /BA/Bedienun g /Schwader/Krei selarme senken/heben/ Kreiselarme heben_I _ohne Einkreiselaus hebung SW 900# Bild @ 161\mod_136 5687596731_78.doc x @ 1418666 @ 22 @ 1
SW9000034
2
1
4
Fig. 28
Pos: 27.19 /BA/Bedienun g /Schwader/Krei selarme senken/heben/ Kreiselarme heben_I _ohne Einkreiselaus hebung SW 900# Text @ 161\mod_136 5687690365_78.doc x @ 1418725 @ 2 @ 1
• Turn on the tractor.
• Raise the rotors to headland position by using the single-action control unit.
• Retract the rotor arms with the double-action control unit until the indicator arrow (4) is in
the centre between 7.8.
• Lower the rotors with the single-action control unit to release the lockings (1).
• Pull the operating cable (2) and keep it under tension to lift the lockings (1).
• Raise the rotors to transport position by using the single-action control unit.
• Release the operating cable.
Pos: 27.20 /BA/Bedienun g /Schwader/Krei selarme senken/heben/ Kreiselarme heben_I I_SW 900# Bild @ 162\mod_1365 761985219_78.doc x @ 1420163 @ @ 1
SW9000035
4
Fig. 29
Pos: 27.21 /BA/Bedienun g /Schwader/Krei selarme senken/heben/ Kreiselarme heben_I I_SW TC 880 Text @ 267\mod_1400740 360243_78.doc x @ 2021964 @ 2222 @ 1
• To ensure a transport height of less than 4 m, retract the working width with the double-
action control unit as far as it will go (the indicator arrow (4) is just ahead of the second
screw).
• Move all hydraulic control units to neutral position.
Pos: 27.22 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ 222222 22 @ 1
To Next Page
Loading...
