Krone Swadro TC 880 - Machine Identification Plate

Commissioning
32
Pos: 23.18 /Übersc hriften/Überschri ften 2/F-J/Fahrtr ichtung regulieren @ 36\mod_1 263299717731_78.doc x @ 338702 @ 32 @ 1
8.7 Regulating direction of travel
Pos: 23.19 /BA/Einste llungen/Schwader/ Fahrtrichtung regu lieren nur von Fachpersona l_Lenkgestänge vorei ngestellt @ 164\mod_1 366197256672_78. docx @ 1427603 @ 3 @ 1
The steering linkage has been pre-adjusted in the factory.
If a machine is hinged, make certain that the machine is driving straight ahead. On a level
street, the machine must run in the centre behind the tractor.
The steering linkage must be readjusted if the machine runs diagonally to the tractor.
Tasks on the steering may only be performed by service technicians (dealers).
Pos: 23.20 /BA/Einste llungen/Schwader/ Fahrtrichtung regu lieren Bild Swadro TC 880_TC 880 X-tr @ 227\mod_1392740839 481_78.docx @ 1828302 @ @ 1
1
2
SW9000028_1
Fig. 12
Pos: 23.21 /BA/Einste llungen/Schwader/ Fahrtrichtung regu lieren Text SW 900# @ 164\mod_13 66196627532_78.doc x @ 1427484 @ @ 1
If the rotary rake is not running in the centre behind the tractor on a level street, this can be
controlled by adjusting the steering linkage (1).
• Loosen counter nut (2).
• Adjusting the steering linkage :
Steering rod shorter => directs machine further to the left
Steering rod longer => directs machine further to the right
• Tighten counter nut (2).
Pos: 23.22 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1