Start-up
45
Pos: 25.32 /Übersc hriften/Überschri ften 2/F-J/Gelenkwel le montieren @ 2\mod_12023983 42788_78.docx @ 59253 @ @ 1
9.6 Install the PTO shaft
Pos: 25.33 /BA/Sic herheit/Gelenkwelle/ Gefahr - Sich dr ehende Gelenkwelle_2 @ 0\mod_11997 81692950_78.doc x @ 34523 @ @ 1
Danger! - Rotating PTO shaft
Effect: Danger to life or serious injuries
• Install or detach the PTO shaft only with the engine switched off and the ignition key
removed.
• Secure the tractor against rolling.
• Make sure that the PTO shaft is coupled properly (the lock of the PTO shaft must have
snapped in).
• Make sure that the protective devices are attached properly.
• Never use a PTO shaft, the protective devices of which have not been attached.
• Replace damaged protective devices immediately
• Attach the safety chain of the PTO shaft so that the guard tube does not rotate
simultaneously with the PTO shaft.
Pos: 25.34 /BA/Sic herheit/Gelenkwelle/ Gefahr - Antriebsdreh zahl 540 beachten @ 3\mod_1 205316518245_78.doc x @ 73595 @ 33 @ 1
Danger! - Observe drive speed
Effect: Danger to life or serious injuries
• This machine is driven at a maximum PTO speed of 540 rpm.
Pos: 25.35 /BA/Inbetr iebnahme/Schwader /Anbau Gelenkwelle/ Anbau Gelenkwelle Bild S wadro TC 880 @ 227\mod_139279564 0656_78.docx @ 1829810 @ @ 1
SW9000006_1
3
3
1
1
2
Fig. 21
Pos: 25.36 /BA/Inbetr iebnahme/Schwader /Anbau Gelenkwelle/ Anbau Gelenkwelle angehän gte Schwader Text_900 # @ 162\mod_13660043202 35_78.docx @ 1420425 @ 2 @ 1
a
• Switch off the engine and remove the ignition key.
• Install the PTO shaft (1) on the machine side (wide angle on machine side).
• Swing the PTO shaft support (2) to the side.
• Then slide the universal shaft on the PTO shaft of the tractor. In doing this, ensure that the
sliding pin is securely engaged.
• Secure PTO shaft guards with retaining chain (3) against turning.
Pos: 25.37 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
To Next Page
Loading...
