Commissioning
37
Pos: 23.27.5.12 /BA/ Einstellungen/Sc hwader/Kreiselfahr werk/Kreiselneig ung einstellen über Langl och_Mittel- und Sei tenschwader @ 247\mod_139 6418696967_78.doc x @ 1924755 @ 2 @ 1
Vernier adjustment by the screw on the oblong hole (3):
− = Reducing rotor inclination
+ = Increasing rotor inclination
Pos: 23.27.5.13 /BA/ Einstellungen/Sc hwader/Kreiselfahr werk/Kreiselneig ung Vorgehensweise Lan gloch_Mittel- und Sei tenschwader @ 247\mod_139 6419664129_78.doc x @ 1924930 @ @ 1
Do not walk beneath the raised rotor.
• Only lift the rotor arms as far as necessary to carry out changes.
• Release the counter nut (1).
• To adjust the guide wheel, turn the stop screw (2) several turns anti-clockwise (upward).
• Release the nuts (3), but make sure the screws still prevent the guide wheel from moving.
• Shift the guide wheel to adjust the rotor pitch.
• Use the stop screw (2) to clamp the rotor at the desired pitch.
• Tighten the counter nut (1).
• Tighten the nuts (3).
Pos: 23.27.5.14 /BA/ Einstellungen/Sc hwader/Kreiselfahr werk/Hinweis sch weres Futter - Fahrwerk innen möglichst niedrig eins tellen @ 4\mod_1213084838 226_78.docx @ 86157 @ 11 @ 1
Note
If the forage is heavy, adjust the inner running gear as low as possible!
Pos: 23.27.5.15 /Layout Module /---------------Seitenumbruch------------- --- @ 0\mod_1196175311226_ 0.docx @ 4165 @ @ 1
To Next Page
Loading...
