Commissioning
39
Pos: 23.27.6.12 /BA/ Einstellungen/Sc hwader/Kreiselfahr werk/Kreiselneig ung einstellen über P latte_Mittel- und Seiten schwader @ 247\mod_1396419 172322_78.doc x @ 1924872 @ @ 1
Vernier adjustment via plate (1):
− = Reducing rotor inclination
+ = Increasing rotor inclination
Pos: 23.27.6.13 /BA/ Einstellungen/Sc hwader/Kreiselfahr werk/Kreiselneig ung Vorgehensweise Plat te_Mittel- und Sei tenschwader @ 247\mod_139 6419978868_78.doc x @ 1924959 @ @ 1
Do not walk beneath the raised rotor.
• Only lift the rotor arms as far as necessary to carry out changes.
• In order to adjust the rotor pitch, disassemble the plate and reposition in the hole pattern.
Pos: 23.27.6.14 /BA/ Einstellungen/Sc hwader/Kreiselfahr werk/Hinweis Einste llung Kreiselneigung - Tandemachse waagerecht @ 224\ mod_139213771560 2_78.docx @ 1811996 @ 3333 @ 1
Note
When adjusting the rotor pitch, ensure the tandem axle (2) is horizontal.
Pos: 23.27.6.15 /BA/ Einstellungen/Sc hwader/Kreiselfahr werk/Hinweis sch weres Futter - Fahrwerk innen möglichst niedrig eins tellen @ 4\mod_1213084838 226_78.docx @ 86157 @ 33 @ 1
Note
If the forage is heavy, adjust the inner running gear as low as possible!
Pos: 24 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.doc x @ 4165 @ @ 1
To Next Page
Loading...
