Driving and Transport
50
Pos: 27.5 /BA/Fahren und Transport/Schwader /Prüfen Sie vor der Straßenf ahrt, dass Swadro TC 880 @ 232\ mod_1393516933450_ 78.docx @ 1852861 @ 3 @ 1
SW9000009
2
1
Fig. 26
Before road travel, make sure that
• the machine is fully and correctly hitched.
• the PTO shaft is switched off and the rotors have come to a standstill.
• the rotors are locked (right and left sides of the machine).
• the machine is in transport position.
• the rotor arms are retracted to the stop (the indicator arrow (1) is located just before the
second screw).
• the control unit is switched off; on machines with electric single-rotor lifting mechanism.
• all hydraulic control units are in neutral position.
• the tines guards (2) are plugged onto the tines which are located in the transport position
below 2 m (right and left sides of the machine).
• the lighting system functions properly.
• the lower links are set to a height of 660 mm to the ground in order to observe the transport
height.
Pos: 27.6 /BA/Fahren und Transport/Schwader /Folgende Arbeitsschr itte werden ... Fahren und Transport_SW 900# @ 161\mod_136 5668926995_78.doc x @ 1416278 @ @ 1
The following work steps are described in this chapter:
– Locking the rotors.
– Raising the rotor arms to transport position.
– Protecting the tine tips.
Pos: 27.7 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
To Next Page
Loading...
