Malfunctions - Causes and Remedies
94
Pos: 42.5 /BA/Störungen - Ursachen und Behebung/ Schwader/Tabellar ische Auflistung Sc hwader 900# @ 161\mod_136566 5821037_78.docx @ 1416 190 @ @ 1
Malfunction Possible cause Remedy
Rotor does not work
smoothly
Raking height set too high Set raking height lower
The working speed is too
high.
Reduce the travelling speed.
Guide value 8 - 10 km/h. For
uneven terrain and/or higher
amount of forage, it may be
necessary to drive slower.
Speed is too low
Increase the speed. Rough
value 450 rpm
Side rotor inclination
adjusted incorrectly.
Change the side inclination
(see chapter Operation
“Setting Rotor Running
Gear”).
Tine arm(s) crooked Replace tine arm(s)
High forage contamination Raking height set too low Set raking height higher
Tine arm(s) bent Replace tine arm(s)
Swath width too large Working width too great Change working width
Speed is too low Increase speed
One rotor goes down in
headland position, the other
goes up.
Rotor not swivelled up into
headland position
Activate hydraulics until the
rotor arms are resting against
the stops.
Not possible to adjust rotor to
unevenness in the ground.
Tractor's lower suspension
arm set too high or too low
Align frame horizontally
(height of the steerable
pinions approx. 66 cm)
Tractor hydraulics not in float
position.
Set tractor hydraulics to float
position.
Setting the raking height -
electrical not working
Fuse defective
Replace the fuse in the
switch box which is screwed
onto the frame.
Pos: 43 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.doc x @ 4165 @ @ 1
To Next Page
Loading...
