Krone Swadro TS 620 - Deviating Tightening Torques MA (Nm); Testing the Screws on the Tines; Tightening Torque of the Wheels on the Chassis

Maintenance
108
Pos: 42.15 /Übersc hriften/Überschri ften 2/A-E/A/Abweichend e Anziehdrehmomen te @ 325\mod_142588786854 2_78.docx @ 2501416 @ 2 @ 1
12.5 Deviating Tightening Torques MA (Nm)
Pos: 42.16 /BA/W artung/Schwader/Zinken / Zin kenarme/Prüfen der S chrauben an den Zinken nach W artungstabelle_Swadr o TS 620(Twin)_TS 680(Twin) _TS 740(Twin @ 238\mod_13 94788714697_78.doc x @ 1882811 @ 3 @ 1
12.5.1 Testing the Screws on the Tines
1
Fig. 62
Testing the Screws on the Tines: According to the Maintenance Table
Pos: 42.17 /BA/W artung/Schwader/Zinken / Zinkenarme/Prüfen der Schrauben an den Zinken_Vor gehen bei abweichendem An zugsdrehmoment @ 240\ mod_1395147752001_78. docx @ 1891022 @ @ 1
When having released the screws,
• remove the nut.
• apply adhesive (high-strength) on the threading overhang of the screw.
• lift the tines on the tine end and tighten the nut to the torque specified below.
Pos: 42.18 /BA/W artung/Reifen/Schwader/ Anziehdrehmoment der Räder am Fahrwerk_ Swadro TS 620( Twin)_TS 680(Twin)_ TS 740(Twin) @ 238\mod_13947 99366371_78.docx @ 1883510 @ 3 @ 1
12.5.2 Tightening Torque of the Wheels on the Chassis
SW9070066_1
Fig. 63
Checking locknut: According to the maintenance table
Pos: 42.19 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1