Start-up
62
Pos: 34.18 /Übersc hriften/Überschri ften 2/F-J/G/Gelenkwel le montieren @ 2\mod_12023 98342788_78.doc x @ 59253 @ 2 @ 1
8.4 Install the PTO shaft
Pos: 34.19 /BA/Er stinbetriebnahme/Gelen kwelle/Traktor wechsel Gelenkwellen länge beachten @ 6\mod_12 14996938591_78.doc x @ 97742 @ @ 1
Caution! - Changing the tractor
Effect: Damage to the machine
When using the machine for the first time and whenever changing the tractor Check PTO shaft
for the correct length. If the length of the PTO shaft does not match the tractor, always observe
the chapter entitled "Adjusting the length of the PTO shaft".
Pos: 34.20 /BA/Inbetr iebnahme/Schwader /Hinweis - Antriebswel le in eine niedrigere Posi tion versetzen @ 510\ mod_1501745781280_78. docx @ 3498136 @ @ 1
Note
If tractors have a low PTO shaft end, the drive shaft of the machine can be moved into a lower
position (II).
To do this:
• Remove the screws (2) from the bearing (1).
• Move the bearing (1) from position (I) into the lower position (II).
• Mount the bearing (1) with the screws (2).
Pos: 34.21 /BA/Inbetr iebnahme/Schwader /Anbau Gelenkwelle/ Anbau Gelenkwelle - ni edrigere Lagerposition f ür die Antriebswelle_ Bild_TS @ 510\mod_1501 598354332_78.docx @ 349598 7 @ @ 1
TS620-011
1
I
II
2
Fig. 26
Pos: 34.22 /BA/Inbetr iebnahme/Schwader /Achtung - Maschinensc häden durch Kollision der Gelenkwelle mit dem Anbau bock @ 510\mod_15015982 35110_78.docx @ 3495955 @ @ 1
ATTENTION!
Machine damage due to collision between the universal shaft and the headstock
If the bearing (1) is in the lower position (II) and the lower links of the tractor are raised higher
than 66 cm, the universal shaft and the headstock may collide.
• Check the length of the universal shaft, see chapter "Length adjustment".
• Do not raise the lower links higher than 66 cm.
Pos: 34.23 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1
To Next Page
Loading...
