Krone Swadro TS 620 - Parking the Machine

Driving and Transport
72
Pos: 36.18.1 /Überschr iften/Überschr iften 2/A-E/AAbstel len @ 0\mod_119980198062 2_78.docx @ 35320 @ 2 @ 1
9.4 Parking
Pos: 36.18.2 /BA/Si cherheit/7. Gefahr enhinweise alt/Schwader /Gefahr - Maschine ab stellen gezogene Gerä te @ 249\mod_139660528893 7_78.docx @ 1933000 @ @ 1
DANGER! - Unexpected movement of the machine!
Danger to life, serious injuries
• No persons may remain in the danger zone.
• Park the machine on a solid surface.
• Before unhitching, switch off the engine, remove the ignition key and carry it with you.
• Secure the machine against rolling by using wheel chocks.
• Use extreme caution when attaching implements to or detaching them from the tractor! The
accident prevention regulations must be complied with absolutely.
• When connecting and disconnecting the hydraulic hose to and from the tractor hydraulics,
the system on the tractor and machine must be pressureless! Move the appropriate control
valves into float position.
Pos: 36.18.3 /BA/Bedi enung /Schwader/Abba u/Abbau vom Traktor Bild S wadro TC 880, TS 620, TS 680, TS 740 @ 235\ mod_1394434210007_78. docx @ 1870135 @ @ 1
8
3
4
5
7
6
1
9
2
SW9000019_1
Fig. 36
Pos: 36.18.4 /BA/Bedi enung /Schwader/Abba uAbbau vom Traktor Text Swa dro TC 680_760 @ 303\mod_1414 138461498_78.doc x @ 2357341 @ @ 1
Choose a level, dry and adequately stable surface.
• Set control unit(s) to float position.
• Switch off tractor and secure it against the possibility of rolling away.
• Secure the machine against the possibility of rolling away by means of wheel chocks (8).
• To swivel the parking support (1) downward, pull the bolt (2), swivel parking support
downward until the bolt locks.
• Lower the lower links until the parking support is on the ground.
• Disconnect universal shaft (3) and lay it down on the support (4).
• Uncouple hydraulic hoses (5) and insert them into the supports.
• Loosen lighting cable (6) between tractor and machine and insert it into the supports
intended for this purpose.
• Disconnect the power supply plug (7) (optional) between tractor and machine and place it in
the supports.
• Put down the operating cable.
• Lower the lower link pinions of the tractor until the tractor can be driven away safely.
Pos: 36.18.5 /BA/Bedi enung /Schwader/Abba u/Abbau vom Traktor_mit Be dieneinheit_Te xt_SW 807-1 bis 810-1, 850, 900# @ 149\mod_1361781174058_ 78.docx @ 1335193 @ @ 1
For design with control unit:
• Remove the control unit (9) from the tractor cabin and mount it on the machine.
Pos: 37 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1