EasyManua.ls Logo

Krone Swadro TS 620 - Preparations for Road Travel

Krone Swadro TS 620
148 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Driving and Transport
70
Pos: 36.7 /Überschri ften/Überschri ften 2/U-Z/VVorbereitu ngen zur Straßenfahr t @ 25\mod_1244092605963_ 78.docx @ 254666 @ 2 @ 1
9.1 Preparations for road travel
Pos: 36.8 /BA/Fahren und Transport/Schwader /Prüfen Sie vor der Straßenf ahrt, dass Swadro TS 620 ( Twin)_TS 680 (Twin)_ TS 740 (Twin) @ 246\mod_139635299 1947_78.docx @ 1923013 @ @ 1
SW9070059
2
1
Fig. 33
Before road travel, make certain that
the machine is fully and correctly hitched.
the PTO shaft is switched off and the rotors have come to a standstill.
the rotors are locked (right and left sides of the machine).
the control unit is switched off, in case of electrically adjustable rotor height.
the machine is in the transport position.
the front swath cloth is swivelled up, in case of swath cloth front design (refer to chapter
Operation “Swivelling up Front Swath Cloth”)
all hydraulic control units are located in neutral position.
the retaining bolts are correctly engaged in the lockings (1) (right and left rotor).
the tine guards (2) are on the tines which are located below 2 m in transport position (right
and left rotor).
the lighting system functions properly.
the lower links are set to a height of 55 cm to the ground to observe the transport height.
Pos: 36.9 /BA/Fahren und Transport/Schwader /Prüfen Sie vor der Straßenf ahrt, dass Zusatz Ausf ührung Twin @ 245\mod_1395842 343303_78.docx @ 1912622 @ @ 1
for Twin design
the rotors are completely retracted in the transport position so that the transport height can
be met.
Pos: 36.10 /BA/Fahren und Transport/Schwader /Hinweis Schutzbüge l und klappbare Zinkenar me in Transportstellu ng reduziert Transpor thöhe @ 156\mod_1363935 125114_78.docx @ 1379336 @ @ 1
Note
With folding tine arms design
The transport height may be reduced additionally if the folding tine arms and the hoop guards
are put into transport position on both machine sides.
Pos: 36.11 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1

Table of Contents

Related product manuals