Operation
85
Pos: 38.23 /BA/Bedienun g /Schwader/Fahrge schwindigkeit und An triebsdrehzahl @ 2\mod_ 1202743688330_78.doc x @ 60967 @ 2 @ 1
10.9 Travelling speed und drive speed
The travelling speed and drive speed while swathing depend on:
• forage quantity
• ground
• degree of dryness
Use these as rough guidelines:
• PTO speed approx. 450 rpm
• Travelling speed approx. 8 - 10 km/h
Drive speed and travel speed must be adapted to each individual operation.
Pos: 38.24 /BA/Bedienun g /Schwader/Hin weis: Fahrgeschwindigk eit @ 77\mod_131010446486 4_78.docx @ 667725 @ @ 1
Note
The travelling speed is based on the work image (orderly rake work with good formation of
swaths).
Pos: 38.25 /Layout Module /----------------Leerzeile-------------------- @ 240\mod_1395147357027_0.doc x @ 1890988 @ @ 1
Pos: 38.26 /Übersc hriften/Überschri ften 2/P-T/S/Schwaden @ 444\ mod_1459947218917_ 78.docx @ 3029731 @ 2 @ 1
10.10 Swathing
Pos: 38.27 /BA/Sic herheit/7. Gefahrenhin weise alt/Schwader /Achtung – Kollision von Traktor und Kreiselschu tzen bei Kurvenfahrte n während des Arbeitseins atzes @ 443\mod_1459839 481203_78.doc x @ 3028265 @ @ 1
CAUTION!
Property damage due to collision between tractor and guards for rotors
When cornering while using the machine for work, the machine may be damaged.
• Choose the minimum curve radius so that the tractor does not touch the guards for rotors.
Pos: 38.28 /BA/Bedienun g /Schwader/Schwaden/ Schwaden_TS 620 (Twin) , TS 680 (Twin), TS 740 (Twin) @ 469\mod_1470384527272 _78.docx @ 3166294 @ @ 1
• Ensure there is no one in the working range of the machine.
• Raise lower links by approx. 100 mm (the height from lower link pinions to ground is
approx. 670 mm).
• Raise outrigger arms into headland position.
• Switch on universal shaft at low engine speed.
• Increase speed slowly to approx. 450 rpm.
• Lower outrigger arms into working position.
• Move single-action control unit to position (“Lower / float position”) to ensure the soil
adaption of the chassis when using the machine for work.
• Select travelling speed so that the crop is picked up cleanly and completely.
• Readjust working height, if necessary.
Pos: 38.29 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1
To Next Page
Loading...
