Krone Swadro TS 620 - Page 117

Maintenance – lubrication
117
Pos: 42.32.8 /BA/W artung/Gelenkwelle sch mieren/Abschmiere n Gelenkwelle neu_TC 880, 930, 1000 und TS_Einleitun g @ 316\mod_142253377006 8_78.docx @ 2446388 @ @ 1
The lubrication point for lubricating the section tube at the rotor’s universal shafts is located
under the bushing (1).
Pos: 42.32.9 /BA/W artung/Gelenkwelle sch mieren/Abschmiere n Gelenkwelle neu_TS 620_680 _740_Bild @ 316\mod_14 22527984062_78. docx @ 2446066 @ @ 1
2
1
TS620-006
Fig. 68
Pos: 42.32.10 /BA/W artung/Gelenkwelle sch mieren/Abschmier en Gelenkwelle neu_TS 620_68 0_740_Text @ 316\mod_14 22528426702_78. docx @ 2446127 @ @ 1
• Retract outrigger arms (only for Twin design).
• Move rotors into working position.
• Push bushings (1) to the side.
• If necessary, turn the rotor until you can see the grease nipple (2).
• After lubrication, push bushings over the lubrication point again.
Pos: 42.32.11 /Layout Module /---------------Seitenumbruch------------- --- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1