Settings
95
Pos: 40.6.5.12 /BA/ Einstellungen/Sc hwader/Kreiselfahr werk/Kreiselneigu ng einstellen über Langloc h_Mittel- und Sei tenschwader @ 247\mod_139 6418696967_78.doc x @ 1924755 @ @ 1
Vernier adjustment by the screw on the oblong hole (3):
− = Reducing rotor inclination
+ = Increasing rotor inclination
Pos: 40.6.5.13 /BA/ Einstellungen/Sc hwader/Kreiselfahr werkKreiselneigung Vor gehensweise Langl och_Mittel- und Seiten schwader @ 306\mod_141586 5553813_78.doc x @ 2375628 @ @ 1
Do not step under the raised rotors.
• Raise the rotor arms only far enough to be able to perform changeover task.
• Loosen the counter nut (1).
• To be able to adjust the guide wheel, turn the stop screw (2) several threads to the top.
• Loosen the nuts (3) until the screws are not loosened completely so that the guide wheel
does not slip.
• Move the guide wheel to set the rotor inclination.
• Fix the adjustment hand-tight by using the stop screw (2).
• Tighten counter nut (1).
• Tighten the nuts (3) with a tightening torque of 200 Nm.
Pos: 40.6.5.14 /BA/ Einstellungen/Sc hwader/Kreiselfahr werk/Hinweis schwer es Futter - Fahrwerk innen mögli chst niedrig einst ellen @ 4\mod_1213084838226 _78.docx @ 86157 @ @ 1
Note
If the forage is heavy, adjust the inner running gear as low as possible!
Pos: 40.6.5.15 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.doc x @ 4165 @ @ 1
To Next Page
Loading...
