Settings
97
Pos: 40.6.6.12 /BA/ Einstellungen/Sc hwader/Kreiselfahr werk/Kreiselneigu ng einstellen über Plat te_Mittel- und Seitensc hwader @ 247\mod_13964191 72322_78.docx @ 1924872 @ @ 1
Vernier adjustment via plate (1):
− = Reducing rotor inclination
+ = Increasing rotor inclination
Pos: 40.6.6.13 /BA/ Einstellungen/Sc hwader/Kreiselfahr werk/Kreiselneigu ng Vorgehensweise Plat te_Mittel- und Seitensc hwader @ 247\mod_13 96419978868_78.doc x @ 1924959 @ @ 1
Do not walk beneath the raised rotor.
• Only lift the rotor arms as far as necessary to carry out changes.
• In order to adjust the rotor pitch, disassemble the plate and reposition in the hole pattern.
Pos: 40.6.6.14 /BA/ Einstellungen/Sc hwader/Kreiselfahr werk/Hinweis Einste llung Kreiselneigung - Tandemachse waagerecht @ 224\ mod_1392137715602 _78.docx @ 1811996 @ @ 1
Note
When adjusting the rotor pitch, ensure the tandem axle (2) is horizontal.
Pos: 40.6.6.15 /BA/ Einstellungen/Sc hwader/Kreiselfahr werk/Hinweis schwer es Futter - Fahrwerk innen mögli chst niedrig einst ellen @ 4\mod_1213084838226 _78.docx @ 86157 @ @ 1
Note
If the forage is heavy, adjust the inner running gear as low as possible!
Pos: 40.7 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_119617531122 6_0.docx @ 4165 @ @ 1
To Next Page
Loading...
