0TDisplay the temperature of the
inverter in the UPS. As the
following graphics shown: the
temperature of the inverter is 37℃.
0TDisplay the voltage and frequency
of the input. As the following
graphics shown: the input voltage is
210v, input frequency is 49.8Hz.
0TDisplay the voltage and capacity of
the battery . As the following
graphics shown: the battery voltage
is 38v, the capacity of battery is
100 ％ (the capacity of battery is
approximately reckoned according
to the battery voltage).
0TDisplay the battery remaining time
when under battery mode. The
number is from 0 to 999 minutes. As
the following graphics shown: there
are 686 minutes left for discharging.
User Settings
The UPS has setting functions. This user settings can be done under any kind of UPS working mode.
The setting will take effect under certain condition. Below table describes how to set the UPS.
Table 6. User Settings
To Next Page
Loading...
Need help?
General
