EasyManuals Logo

KTM 250 EXC EU User Manual

KTM 250 EXC EU
289 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #104 background imageLoading...
Page #104 background image
15 WIRING HARNESS, BATTERY 102
Warning
Environmental hazardHazardous substances cause environmental damage.
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Even when there is no load on the battery, it still loses power steadily.
The charge state and the type of charge are very important for the service life of the battery.
Rapid recharging with a high charging current shortens the battery's service life.
If the charging current, charging voltage and charging time are exceeded, electrolyte escapes through the safety valves. This
reduces the battery capacity.
If the battery is depleted from starting the vehicle repeatedly, the battery must be charged immediately.
If the battery is left in a discharged state for an extended period, it will become over-discharged and sulfate, destroying the
battery.
The battery is maintenance-free, i.e., the acid level does not have to be checked.
Preparatory work
Switch off all power consumers and the engine.
Remove the seat. ( p. 85)
Disconnect the minus (negative) cable of the battery to avoid damage to the motor-
cycle's electronics.
400240-10
Main work
Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (58429074000)
You can also use the battery charger to test rest potential and start potential of the
battery, and to test the alternator. With this device, you cannot overcharge the bat-
tery.
Info
Never remove the lid
1
.
Charge the battery with at most 10% of the capacity specified on the bat-
tery
2
.
Switch off the charger after charging. Disconnect the battery.
Guideline
The charge current, charge voltage and charge time must not be exceeded.
Charge the battery regularly when the
motorcycle is not in use
3 months
Finishing work
Mount the seat. ( p. 86)
15.5 Disconnecting the negative cable of the battery
Preparatory work
Remove the seat. ( p. 85)
303411-10
Main work
Disconnect the negative (minus) cable
1
of the battery.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KTM 250 EXC EU and is the answer not in the manual?

KTM 250 EXC EU Specifications

General IconGeneral
Transmission6-speed
IgnitionKokusan
Front Wheel1.60 x 21"
Rear Wheel2.15 x 18"
Seat Height960 mm
Engine Type2-stroke
Displacement249 cm³
Bore x Stroke66.4 mm x 72 mm
CoolingLiquid-cooled
Front SuspensionWP Xplor 48, USD fork
Rear SuspensionWP XPLOR shock absorber with linkage
Front BrakeDisc brake
Rear BrakeDisc brake
Fuel Capacity9 l

Related product manuals