12 SERVICE WORK ON THE CHASSIS 72
S00831-10
–
Plug in connector
of the fuel pump.
– Remove the wash cap set.
– Thoroughly clean the plug-in connection of the fuel line using compressed air.
Info
Under no circumstances should dirt enter into the fuel line. Dirt in the fuel
line clogs the injection valve.
–
Lubricate the O-ring and connect plug-in connection
of the fuel line.
Info
Route the cable and fuel line at a safe distance from the exhaust system.
Finishing work
– Mount the seat. ( p. 64)
12.35 Checking for chain dirt accumulation
400678-01
– Check the chain for coarse dirt accumulation.
» If the chain is very dirty:
– Clean the chain. ( p. 72)
12.36 Cleaning the chain
Warning
Danger of accidents Oil or grease on the tires reduces their grip.
– Remove oil and grease with a suitable cleaning material.
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
– Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Environmental hazard Hazardous substances cause environmental damage.
– Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
The service life of the chain depends largely on its maintenance.
Preparatory work
– Raise the motorcycle with the lift stand. ( p. 50)
400725-01
Main work
– Clean the chain regularly and then treat with chain spray.
Chain cleaner ( p. 126)
Off-road chain spray ( p. 126)
Finishing work
– Remove the motorcycle from the lift stand. ( p. 50)
To Next Page
Loading...
