14 ELECTRICAL SYSTEM 84
Finishing work
– Check the headlight setting. ( p. 85)
14.9 Changing the headlight bulb
Note
Damage to reflector Reduced luminance.
– Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
Preparatory work
– Remove the headlight mask with the headlight. ( p. 83)
101403-10
Main work
– Turn rubber cap 1 together with the underlying lamp socket counterclockwise all
the way and remove it.
– Pull lamp socket 2 of the parking light out of the reflector.
100862-10
– Press headlight bulb 3 into the lamp socket lightly, turn it counterclockwise all the
way and pull it out.
– Insert a new headlight bulb.
Headlight (S2 / socket BA20d) ( p. 106)
– Insert the rubber cap together with the lamp socket into the reflector and turn it
clockwise all the way.
Info
Ensure that the O-ring 4 is seated properly.
– Insert the lamp socket of the parking light into the reflector.
Finishing work
– Refit the headlight mask with the headlight. ( p. 83)
– Check the headlight setting. ( p. 85)
14.10 Changing the turn signal bulb
Note
Damage to reflector Reduced luminance.
– Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
To Next Page
Loading...
