MAINTENANCE WORK ON CHASSIS AND ENGINE 65
400240-10
– Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (58429074000)
You can also use the battery charger to test rest potential and start potential of the
battery, and to test the generator. With this device, you cannot overcharge the bat-
tery.
Info
Never remove the lid .
Charge the battery with at most 10% of the capacity specified on the bat-
tery .
– Switch off the charger after charging. Disconnect the battery.
Guideline
The charge current, charge voltage and charge time must not be exceeded.
Charge the battery regularly when the
motorcycle is not in use.
3 months
– Mount the seat. ( p. 66)
9.78Removing a fuse
– Switch off all power-consuming components and switch off the engine.
– Dismount the air filter box lid. ( p. 70)
400270-10
– Remove the protection cover .
Info
The fuse is located in the starter relay under the filter box cover.
– Remove the fuse .
9.79Installing the fuse
Warning
Fire hazard The electrical system can be overloaded by the use of incorrect fuses.
– Use only fuses with the prescribed amperage. Never by-pass or repair fuses.
400273-10
– Insert the fuse.
Fuse (58011109110)
Info
A reserve fuse is located in the starter relay.
Replace a burned-out fuse only by an equivalent fuse.
If the new fuse burns out, contact an authorized KTM workshop.
– Replace the protection cover.
– Install the air filter box lid. ( p. 70)
9.80Removing the seat
500080-10
– Remove screw . Lift up the seat at the rear, pull it back and then remove from
above.
To Next Page
Loading...
