KTM 530 EXC - Gear Oil Maintenance; Changing Gear Oil and Cleaning Screen; Draining Gear Oil and Cleaning Screen; Filling Gear Oil

MAINTENANCE WORK ON CHASSIS AND ENGINE 76
9.106Removing the oil filter x
Warning
Danger of scalding Engine oil and gear oil get very hot when the motocycle is driven.
– Wear suitable protective clothing and gloves. If you scald yourself, hold the affected area under cold water immediately.
Warning
Environmental hazard Problem materials cause environmental damage.
– Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
– Place a suitable container under the engine.
200113-10
– Remove screws . Remove oil filter cover  with O-ring.
200114-10
– Pull the oil filter insert  out of the oil filter casing.
Circlip pliers reverse (51012011000)
– Completely drain the engine oil.
– Thoroughly clean parts and sealing area.
9.107Installing the oil filter x
200114-11
– Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
– Fill the oil filter  with engine oil and place it in the oil filter container.
– Lubricate the O/ring  of the oil filter cover.
200113-11
– Mount oil filter cover .
– Mount and tighten screws .
Guideline
Screw, oil filter cover M6 10 Nm (7.4 lbf ft)
– Stand the motorcycle up.