MAINTENANCE WORK ON CHASSIS AND ENGINE 79
9.114Adding gear oil x
Info
Too little gear oil or poor-quality oil results in premature wear to the transmission.
200116-10
– Remove gear oil level check screw .
200118-11
– Remove screw cap . Stand the vehicle upright.
– Add gear oil until it flows out of the bore of the gear oil level screw.
Engine oil (SAE 10W/50) ( p. 97)
– Mount and tighten the gear oil level check screw.
Guideline
Screw, gear oil level check M6 8 Nm (5.9 lbf ft)
– Mount and tighten screw cap .
Danger
Danger of poisoning Exhaust gases are poisonous and can result in uncon-
sciousness and/or death.
– When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in a closed space.
– Start the engine and check that it is oil-tight.
To Next Page