MAINTENANCE WORK ON CHASSIS AND ENGINE 70
800020-10
– Disconnect spring .
– Remove screws and take off main silencer.
9.91Installing the main silencer
800020-11
– Mount the main silencer. Mount and tighten screws .
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
– Reconnect spring .
9.92Dismounting the air filter box lid
800021-10
– Pull off the air filter box lid in area to the side and remove to the front.
9.93Installing the air filter box lid
800021-11
– Insert the air filter box lid into the rear area and clip it into the front area .
9.94Removing the air filter x
Note
Engine failure Unfiltered intake air has a negative effect on the service life of the engine.
– Never ride the vehicle without an air filter since dust and dirt can get into the engine and result in increased wear.
Warning
Environmental hazard Problem materials cause environmental damage.
– Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
– Dismount the air filter box lid. ( p. 70)
To Next Page
Loading...
