7 PREPARING FOR USE
28
– Run the engine in. ( p. 28)
7.2 Running in the engine
– During the run-in phase, do not exceed the specified vehicle speed in the respective gear.
Guideline
During the first 1,000 km (620 mi)
Maximum speed per gear
First gear 50 km/h (31.1 mph)
Second gear 70 km/h (43.5 mph)
Third gear 90 km/h (55.9 mph)
Fourth gear 110 km/h (68.4 mph)
Fifth gear 125 km/h (77.7 mph)
Sixth gear 140 km/h (87 mph)
– Avoid fully opening the throttle!
7.3 Loading the vehicle
Warning
Danger of accidents Total weight and axle loads influence the handling characteristic.
The total weight consists of: motorcycle ready for operation and with a full tank, driver and passenger
with protective clothing and helmet, and luggage.
– Do not exceed the maximum permissible overall weight or the axle loads.
Warning
Danger of accidents Improper mounting of cases or the tank rucksack impairs the handling characteris-
tic.
– Mount and secure cases and tank rucksack according to the manufacturer's instructions.
Warning
Danger of accidents Carrying luggage alters handling characteristics at high speed.
– Adapt your speed to your payload.
– Ride more slowly if your motorcycle is loaded with cases or other luggage.
Maximum speed with baggage 130 km/h (80.8 mph)
Warning
Danger of accidents The luggage system will be damaged if it is overloaded.
– Read the manufacturer information on maximum payload when mounting cases.
Warning
Danger of accidents Luggage which has slipped impairs visibility.
If the tail light is covered, you are less visible to traffic behind you, especially when it is dark.
– Check that your luggage is fixed properly at regular intervals.
Warning
Danger of accidents A high payload alters the handling characteristic and increases the stopping
distance.
– Adapt your speed to your payload.
To Next Page
Loading...
Need help?
General
