15 COOLING SYSTEM
90
S03316-10
– Place the motorcycle on a horizontal surface using the side
stand.
–
Remove the cover of compensating tank
1
.
– Check the antifreeze in the coolant.
−25 … −45 °C (−13 … −49 °F)
» If the antifreeze in the coolant does not match the speci-
fied value:
– Correct the antifreeze in the coolant.
– Check the coolant level in the compensating tank.
The coolant level must be between the two markings.
» If the coolant level does not match the specified value:
– Correct the coolant level.
Coolant ( p. 118)
– Mount the cover of the compensating tank.
S03317-10
–
Remove radiator cap
2
.
– Check the antifreeze in the coolant.
−25 … −45 °C (−13 … −49 °F)
» If the antifreeze in the coolant does not match the speci-
fied value:
– Correct the antifreeze in the coolant.
– Check the coolant level in the radiator.
The radiator must be filled completely.
» If the coolant level does not match the specified value:
– Check the coolant level and the reason for the loss.
Coolant ( p. 118)
– Mount the radiator cap.
15.3 Checking the coolant level
Warning
Danger of scalding During motorcycle operation, the coolant gets very hot and is under pressure.
– Do not open the radiator, the radiator hoses or other cooling system components if the engine or the
cooling system are at operating temperature.
–
Allow the cooling system and the engine to cool down before you open the radiator, the radiator hoses
or other components of the cooling system.
– In the event of scalding, rinse the area affected immediately with lukewarm water.
To Next Page
Loading...
Need help?
General
