15 COOLING SYSTEM
92
Condition
– The engine is cold.
K00402-10
– Position the motorcycle upright.
– Position an appropriate container under the engine.
–
Remove screw
1
. Take off the radiator cap.
– Completely drain the coolant.
–
Mount and tighten screw
1
with a new seal ring.
Guideline
Screw plug, water
pump drain hole
M10x1 15 Nm (11.1 lbf ft)
15.5 Filling/bleeding the cooling system
Warning
Danger of poisoning Coolant is toxic and a health hazard.
– Keep coolant out of the reach of children.
– Do not allow coolant to come into contact with the skin, the eyes and clothing.
– Consult a doctor immediately if coolant is swallowed.
– Rinse the affected area immediately with plenty of water in the event of contact with the skin.
– Rinse eyes thoroughly with water and consult a doctor immediately if coolant gets into the eyes.
– Change clothing if coolant spills onto your clothing.
E00522-10
– Stand the motorcycle on a level surface using the side stand.
–
Remove radiator cap
1
.
S03318-10
– Refill with coolant.
Coolant ( p. 118)
– Completely fill the radiator with coolant.
–
Mount radiator cap
1
.
To Next Page
Loading...
