15 COOLING SYSTEM
94
S03318-11
–
Remove radiator cap
2
.
– Completely drain the coolant.
K00402-10
–
Mount and tighten screw
1
with a new seal ring.
Guideline
Screw plug, water
pump drain hole
M10x1 15 Nm (11.1 lbf ft)
S03318-11
– Stand the motorcycle on a level surface using the side stand.
– Refill with coolant.
Coolant 1.20 l
(1.27 qt.)
Coolant ( p. 118)
– Completely fill the radiator with coolant.
–
Mount radiator cap
2
.
S03316-12
–
Remove cover
3
of the compensating tank.
– Add coolant to the top marking.
– Mount the cover of the compensating tank.
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
– Always make sure there is sufficient ventilation
when running the engine.
– Use effective exhaust extraction when starting or
running the engine in an enclosed space.
– Start the engine and allow it to warm up.
– Stop the engine and allow it to cool down.
Finishing work
– Check the coolant level. ( p. 90)
To Next Page
Loading...
Need help?
General
