KTM Freeride 350 - Service Work on the Chassis; Fork and Triple Clamp Service

SERVICE WORK ON THE CHASSIS 37
10.1Raising the motorcycle with the lift stand
Note
Danger of damage The parked vehicle may roll away or fall over.
– Always place the vehicle on a firm and even surface.
B01029-10
– Raise the motorcycle at the frame underneath the engine.
Lift stand (54829055000)
The wheels must no longer touch the ground.
– Secure the motorcycle against falling over.
10.2Removing the motorcycle from the lift stand
Note
Danger of damage The parked vehicle may roll away or fall over.
– Always place the vehicle on a firm and even surface.
B01025-10
– Remove the motorcycle from the lift stand.
– Remove the lift stand.
– To park the motorcycle, press side stand 1 to the ground with your foot and lean
the motorcycle on it.
Info
When you are riding, the side stand must be folded up and secured with the
rubber band.
10.3Bleeding the fork legs
Preliminary work
– Raise the motorcycle with the lift stand. ( p. 37)
B01037-10
Main work
– Remove bleeder screws 1 briefly.
Any excess pressure escapes from the interior of the fork.
– Mount and tighten bleeder screws.
Follow-up work
– Remove the motorcycle from the lift stand. ( p. 37)
10.4Cleaning the dust boots of the fork legs
Preliminary work
– Raise the motorcycle with the lift stand. ( p. 37)