SERVICE WORK ON THE ENGINE 86
» If the engine oil is not up to the middle A of the level viewer:
– Add engine oil. ( p. 87)
16.3Changing the engine oil and oil filter, cleaning the oil screen x
Warning
Danger of scalding Engine oil and gear oil get very hot when the motorcycle is ridden.
– Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
– Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Drain the engine oil only when the engine is warm.
Preliminary work
– Park the motorcycle on a level surface.
– Remove the engine guard. ( p. 58)
B01125-10
Main work
– Place a suitable container under the engine.
– Remove the oil drain plug 1 with the magnet and seal ring.
Info
Do not remove screws A on both sides.
B01126-10
– Remove plug 2 with oil screen 3 and the O-rings.
B01128-10
– Remove screws 4. Remove the oil filter cover with the O-ring.
B01129-10
– Pull oil filter 5 out of the oil filter housing.
Circlip pliers reverse (51012011000)
– Completely drain the engine oil.
– Thoroughly clean the parts and sealing area.
To Next Page
Loading...
