EasyManua.ls Logo

KTM Freeride 350 - Installing the Fuel Tank

KTM Freeride 350
113 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SERVICE WORK ON THE CHASSIS 49
B01076-10
Disconnect connector 4.
Pull off engine breather hose 5.
B01077-10
Release hose clamp 6.
Detach the intake flange from the throttle valve body.
B01078-10
Pull up the fuel tank slightly and disconnect connector 7 of the fuel pump.
Remove the fuel tank from above.
10.29Installing the fuel tank x
Danger
Fire hazardFuel is highly flammable.
Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
Fuel in the fuel tank expands when warm and can escape if the tank is overfilled. See the notes on refueling.
Warning
Danger of poisoningFuel is poisonous and a health hazard.
Avoid contact of the fuel with skin, eyes and clothing. Do not inhale fuel vapors. If fuel gets into your eyes, rinse imme-
diately with water and contact a doctor. Wash affected skin areas immediately with soap and water. If fuel is swallowed,
contact a doctor immediately. Change clothing that has come into contact with fuel.
B01078-11
Main work
Check the throttle cable routing. ( p. 55)
Make sure that no cables are trapped or damaged.
Attach connector 1 of the fuel pump.

Table of Contents

Related product manuals