Using fuel
Temperature fuel
Above -10 ℃ (14 ℉) Grade No.2-Diesel fuel
Below -10 ℃ (14 ℉) Grade No.1-Diesel fuel
1. Turn the key switch to the on position and check
the amount of fuel by the fuel gauge.
2. Fill the fuel tank with fuel when the fuel gauge
shows as follows.
Amount of fuel for refueling 1/4 or less in the fuel tank
Fuel tank capacity
25 L
(6.6 U.S.gals.)
(1) Fuel tank cap
3. Checking the engine oil level
WARNING
To avoid serious injury or death:
• Be sure to stop the engine before checking the
engine oil level.
IMPORTANT :
• When using an engine oil of different maker or
viscosity from the previous one, remove all of
the old oil and oil filter. Never mix two different
types of oil.
• If the engine oil level is low, do not run the
engine.
• When using the BT603 Backhoe and checking
oil level, locate the tractor, the loader, and the
backhoe on a flat surface and set the loader and
the backhoe as illustrated as follows.
1. Park the machine on a firm, flat, and level surface.
2. Check the engine oil before starting the engine, or,
after five minutes or more when the engine has
been stopped.
3. To check the engine oil level, draw out the dipstick,
wipe it clean, replace it, and draw it out again.
4. Check to see that the engine oil level lies between
the two notches.
5. If the engine oil level is too low, add new oil to the
prescribed level at the oil inlet.
See LUBRICANTS, FUEL, AND COOLANT TABLE
on page 115.
(1) Oil inlet
(2) Dipstick
(A) Engine oil level is acceptable
within this range
4. Checking the transmission fluid
level
WARNING
To avoid serious injury or death:
• Park the tractor on a firm, flat, and level surface,
lower the implement to the ground, and shut off
the engine.
IMPORTANT :
• If the transmission fluid level is low, do not run
the engine.
PERIODIC SERVICE OF THE TRACTOR
DAILY CHECK OF THE TRACTOR
To Next Page
Loading...
