Control box
36
Quantron S
Machine use
The control box calculates the new opening required and
displays it on the screen.
- Adapt metering unit opening according to the value
displayed on the screen (See corresponding manual).
- Press Enter key.
- Shut-off the calibration flap.
- Press Enter key.
The calibration test is accepted. Settings will be stored in
the Private list under the saved name.
- Press Enter key.
The machine is ready for work.
In most cases, it is not necessary to adjust the
metering unit opening, as the electric or
hydraulic drive adjusts the rotation speed.
If a new calibration test is required, repeat
procedure with the new metering unit opening.
To Next Page
Loading...