Control box
54
Quantron S
System/Test
2. Alarm configuration
The submenu Alarm configuration allows to deactivate
following sensors if they are broken. The machine can
continue to work.
• Blower
• Calibration flap
• Low level sensors (UP/DOWN)
• Power harrow sensor
- Uncheck the box corresponding to the faulty sensor:
Press Enter key.
Only the sensors which are mounted and
stored in the menu "Machine options" are shown
on the screen. See chapter Service: Machine
configuration
Replace broken sensors as soon as possible.
Reactivate the required alarm configuration.
To Next Page
Loading...