Kuka KR C4 compact - 5.1.3 EC Declaration of Conformity and Incorporation; 5.1.4 Terms Used

28 / 93 Issued: 20.04.2018 Version: Spez KR C4 compact V10
KR C4 compact
 Use as a climbing aid
 Operation outside the specified operating parameters
 Operation without the required safety equipment
5.1.3 EC declaration of conformity and declaration of incorporation
The industrial robot constitutes partly completed machinery as defined by the
EC Machinery Directive. The industrial robot may only be put into operation if
the following preconditions are met:
 The industrial robot is integrated into a complete system.
or: The industrial robot, together with other machinery, constitutes a com-
plete system.
or: All safety functions and safeguards required for operation in the com-
plete machine as defined by the EC Machinery Directive have been added
to the industrial robot.
 The complete system complies with the EC Machinery Directive. This has
been confirmed by means of a conformity assessment procedure.
EC declaration of
conformity
The system integrator must issue an EC declaration of conformity for the com-
plete system in accordance with the Machinery Directive. The EC declaration
of conformity forms the basis for the CE mark for the system. The industrial
robot must always be operated in accordance with the applicable national
laws, regulations and standards.
The robot controller has a CE mark in accordance with the EMC Directive and
the Low Voltage Directive.
Declaration of
incorporation
The partly completed machinery is supplied with a declaration of incorporation
in accordance with Annex II B of the EC Machinery Directive 2006/42/EC. The
assembly instructions and a list of essential requirements complied with in ac-
cordance with Annex I are integral parts of this declaration of incorporation.
The declaration of incorporation declares that the start-up of the partly com-
pleted machinery is not allowed until the partly completed machinery has been
incorporated into machinery, or has been assembled with other parts to form
machinery, and this machinery complies with the terms of the EC Machinery
Directive, and the EC declaration of conformity is present in accordance with
Annex II A.
5.1.4 Terms used
STOP 0, STOP 1 and STOP 2 are the stop definitions according to EN 60204-
1:2006.
Term Description
Axis range Range of each axis, in degrees or millimeters, within which it may move.
The axis range must be defined for each axis.
Stopping distance Stopping distance = reaction distance + braking distance
The stopping distance is part of the danger zone.
Workspace Area within which the robot may move. The workspace is derived from
the individual axis ranges.
User The user of the industrial robot can be the management, employer or
delegated person responsible for use of the industrial robot.
Danger zone The danger zone consists of the workspace and the stopping distances
of the manipulator and external axes (optional).