What to do if my Kyocera All in One Printer displays 'Cannot send document.'?
First, check if the modular cord is correctly connected. If a 'Communication error' is displayed, address the cause of the error and try sending again. Also, verify whether the TX (transmission) restriction is activated and, if so, cancel it.
What to do if my Kyocera All in One Printer displays 'Cannot receive document.'?
Check that the modular cord is correctly connected. If a communication error is displayed, resolve the error and ask the sender to resend the document. Also, make sure that RX (reception) restriction is not activated; if it is, cancel the RX restriction.
What to do if my Kyocera All in One Printer displays 'Job Accounting restriction exceeded.'?
This message appears when the number of pages used has exceeded the limit set in Job Accounting. Press the OK key to cancel the current job. To proceed, reset the limit for paper use in the Job Accounting settings and try the job again.
Why does my Kyocera Printer paper often jam?
Paper jams in your Kyocera Printer can occur due to several reasons. Ensure the paper is loaded correctly. If it is a supported type and in good condition, try removing it, turning it over, and reloading it. Replace any curled, folded, or wrinkled paper with new paper. Also, check for and remove any loose scraps or jammed paper inside the machine.
Why are images skewed on my Kyocera ECOSYS FS-1135MFP Printer?
If images are skewed when using your Kyocera Printer, check that the originals are placed correctly. When using the platen, align them with the slit glass. When using the document processor, align the original width guides securely before placing the originals. Also, ensure the paper is loaded correctly by checking the position of the paper width guides.
Why are Kyocera ECOSYS FS-1135MFP printouts wrinkled?
If the printouts from your Kyocera Printer are wrinkled or curled, the paper might be damp. Replace the paper with new paper.
What to do if pressing Start key on Kyocera ECOSYS FS-1135MFP Printer does not produce copies?
If pressing the Start key on your Kyocera Printer does not produce copies, check the Message Display for any messages and respond accordingly. Also, check if the machine is in Sleep mode; if so, press any key on the operation panel to recover the machine. It will be ready to copy within 15 seconds.
How to remove moire pattern from Kyocera Printer copies?
If copies from your Kyocera Printer have a moire pattern, and the original is a printed photograph, set the image quality to [Photo].
Why are my Kyocera ECOSYS FS-1135MFP Printer printouts fuzzy?
If the printouts from your Kyocera Printer are fuzzy, and the machine is being used in very humid conditions, move it to a location with suitable humidity.
How to fix Kyocera Printer cannot feed originals?
If your Kyocera Printer cannot feed originals, when placing originals in the document processor, align the original width guides securely before placing the originals.
General| Print Technology | Laser |
|---|---|
| Print Resolution | 1200 x 1200 dpi |
| Duplex Printing | Yes |
| Standard Memory | 256 MB |
| Connectivity | USB 2.0, Ethernet |
| Scanner Type | Flatbed, ADF |
| Scan Resolution | 600 x 600 dpi |
| Copier Resolution | 600 x 600 dpi |
| Fax Capability | Yes |
| Fax Transmission Speed | 33.6 kbps |
| Maximum Paper Size | A4 |
| Operating System Compatibility | Windows, Mac OS, Linux |
| Dimensions | 494 x 430 x 448 mm |
| Print Speed | 35 ppm |
| Standard Input Capacity | 250 sheets |
| Copy Speed | Up to 35 cpm |
| Maximum Input Capacity | 800 sheets (with optional paper feeders) |
To Next Page