Kyocera ECOSYS FS-3540MFP - COMMAND CENTER (Settings for E-Mail)

2-21
Preparation before Use > COMMAND CENTER (Settings for E-mail)
COMMAND CENTER (Settings for E-mail)
COMMAND CENTER is a tool used for tasks such as verifying the operating status of the machine and changing the
settings for security, network printing, E-mail transmission and advanced networking.
1
Display the screen.
1 Launch your Web browser.
2 In the Address or Location bar, enter the machine’s IP address.
E.g.) http://192.168.48.21/
The web page displays basic information about the machine and COMMAND CENTER as
well as their current status.
2
Configure the function.
Select a category from the navigation bar on the left of the screen. The values for each
category must be set separately.
If restrictions have been set for COMMAND CENTER, enter a password to access pages
other than the startup page. The default password is “admin00”. The password can be
changed.
For details, refer to the KYOCERA COMMAND CENTER Operation Guide.
NOTE
Here, information on the FAX settings has been omitted. For more information on using the
FAX, refer to the FAX Operation Guide.
FAX functions are available only on products with the fax function installed.