11-4
Troubleshooting > General Troubles
Printouts are curled.
― Remove the paper from the cassette,
turn the stack over, and reload the
paper. You can also try turning the
paper around 180 degrees.
3-18
Is the paper damp? Replace the paper with new paper. 3-17
If the problem occurs frequently, turn
on the Cassette Heater switch.
2-5
The printer driver
won't install.
While Wi-Fi or the Wi-Fi Direct
function is enabled, are you trying to
install the driver using the host
name?
Instead of the host name, specify the
IP address.
2-28
Cannot print.
Check the power cord. Connect both ends of the power cord
securely.
2-9
Is the machine powered on? Turn on the power switch. 2-10
Are the USB cable and network cable
connected?
Connect the correct USB cable and
network cable securely.
2-9
2-9
Is the print job paused? Resume printing. 7-9
If wired or Wi-Fi network settings
were configured using name
resolution, is there intermixing with
an IP address (private address) of
another network that cannot access?
Only one host name and one domain
name can be used with the MFP.
Configure network settings keeping
this restriction in mind.
―
Use Command Center RX to change
the NetBEUI, DNS, and other name
resolution settings, or change the
network environment settings.
CommandCen
ter RX User
Guide
On the Primary Network (Client),
select Wi-Fi, Wired Network, or
Optional Network as an unlimited-use
network.
8-50
With the protocol settings, select
[Enable] for either the [Wired
Network] or [Wi-Fi] setting, and
[Disable] for the other setting.
8-40
Cannot print with
USB memory.
USB memory not
recognized.
Is the USB host blocked[Block]? Select [Unblock] in the USB host
settings.
8-50
― Check that the USB memory is
securely plugged into the machine.
―
While “On" is set to
[Auto-IP], the IP
address is not
assigned
automatically.
Is a value other than "0.0.0.0"
entered for the IP address of TCP/
IP(v4)?
Enter "0.0.0.0" for the IP address of
TCP/IP(v4).
2-13
Symptom Checkpoints Corrective Actions Reference
Page
To Next Page
Loading...
